Lifegear - Active Plus Programmable Motorized Treadmill (97785J)
• Motor Duty: 1.5 HP (Continue); 2.5 HP (Peak)
• Speed Range: 1.0~16 Km/Hr
• 3-Level Manual Incline
• Voltage: 220 Volt (110V Available)
• Manual Fold Up with Gas Assist
• None Impact Cushion Deck
• 6 Instant Speed Buttons (2, 4, 6, 8, 10, 12)
• Start/Stop & Speed Buttons on the Handrails
• Built-in Transport Wheels for Easy Transport and Storage
• Running Surface: 129 L x 41 W (cm)
LIFTING UP & SETTING DOWN THE TREADMILL LIFTING UP THE TREADMILL Firmly grasp the Handle of the main frame with one hand. Carefully lift the end of the treadmill up into the upright position until the Foot Lock Latch engages and securely locks the main frame into position. Make sure the main frame is securely latched before moving the treadmill. See figures A and B. Store the treadmill in a clean and dry environment away from children.
SETTING DOWN THE TREADMILL To set down the treadmill, firmly grasp the back end of the treadmill with both hands. Gently kick on the Foot Lock Latch with your foot until the lock latch disengages. Carefully lower the deck to the ground. See figures C and D.
NOTE: DO NOT STAND UNDER THE DECK WHEN SETTING DOWN THE TREADMILL. TO PREVENT INJURY, PLEASE MAKE SURE YOU HAVE A FIRM HOLD WHEN LIFTING UP OR SETTING DOWN THE DECK.
There are 3 incline angles that the Incline Adjuster can be set to. Place one hand on the Handle of the main frame, then lift the rear end of the main frame up and use the other hand to remove the Lock Pin. Adjust the Incline Adjuster to the desired position and insert the Lock Pin into the holes on the main frame and Incline Adjuster to lock the Incline Adjuster in place.
NOTE: Make sure when adjusting the incline angle of the Incline Adjuster that both Incline Adjusters should be adjusted to the same angle. Using the Incline Adjusters at different angles can cause the treadmill to be unstable and cause injury.
The unit can be carefully tilted onto its transport wheels for easy moving and storage. With the treadmill in the folded locked position (foot lock latch is engaged), firmly grasp the Rear End of the Main Frame with both hands and place one foot onto the Transport Wheel Cap Set. Next, carefully tilt the treadmill back until it rolls freely on the transport wheels. To set the treadmill down, place one foot on the Transport Wheel Cap Set and carefully lower treadmill onto base in the folded position.
CAUTION: The treadmill is heavy, it is suggested you always use the aid of a second person when moving the treadmill. Do not attempt to move the treadmill while it is in the unfolded position.